DOI: 10.1016/J.ENERGY.2018.12.216 Corpus ID: 117248330; Influence of particle sizes on combustion characteristics of coal particles in oxygen-deficient atmosphere @article{Cong2019InfluenceOP, title={Influence of particle sizes on combustion characteristics of coal particles in oxygen-deficient atmosphere}, …
This work aims to numerically investigate characteristics of Na under Oxy-steam atmosphere, mainly related to temperature, steam concentration, particle size and modification methods of kaolinite. Results indicated that the high temperature promoted the release of Na: compared with 750 °C, the Na content in ash at 950 °C has dropped by …
STEAM EXPLODED PINE WOOD: FLAME SPEED AND Kst AS A FUNCTION OF PARTICLE SIZE. M.A. Saeed, N.F. Áñez, G. E. Andrews, H.N. Phylaktou & B.M. Gibbs. School of Chemical and Process Engineering, University of Leeds, UK 3 11th European Conference on Coal Research and its Applications
1. Introduction. Char gasification is an important stage during the thermochemical conversion of solid fuels (e.g., coal and biomass). To improve the gasification efficiency, steam or CO 2 are usually added into the gasifying agent in industrial applications like fluidized-bed and entrained-flow reactors [1, 2].Taking biomass for …
The corresponding average activation energy (Ea) range of different size coal samples varied within the range of 62.1–191.8 kJ/mol, and the lowest Ea found for the largest particle size coal ...
The feed coal (40 g) with a particle size of 5–13 mm (the particle size range of coal used in the gasification site is 5–50 mm) was put into the pressurized fixed-bed gasifier and heated to 1100 °C with a rate of 10 °C/min at 4 MPa, and Al 2 O 3 porcelain balls were placed underneath and on the coal samples. The gasification agent mixture ...
Additionally, the ways in which some factors such as coal particle size, heating temperature etc. influence the fragmentation has been extensively investigated previously [7, 17, 24]. ... The effect of coal particle size on pyrolysis and steam gasification. Fuel, 81 (2002), pp. 531-537, 10.1016/S0016-2361(01)00153-3.
Char gasification is affected by operating conditions such as reaction temperature, reactant gas partial pressure, total system pressure, and particle size, in addition to the chemical composition and the physical structure of the coal. We characterized the effects of coal type and particle size on the CO2 gasification of chars prepared from 12 bituminous …
In PC combustion, the coal is dried and is ground to a specified fineness, with a maximum particle size of 250–300 μm, depending on the reactivity of the coal. Coal preparation, which involves feeding, drying, and grinding of the coal, and the pneumatic transport of the pulverized coal to the burners, is fully integrated with the boiler.
Char gasification is affected by operating conditions such as reaction temperature, reactant gas partial pressure, total system pressure, and particle size, in addition to the chemical …
In this system coal particles sized up to 3 mm, perhaps up to 6 mm in a commercial plant, are pyrolysed and then gasified in air/steam in a spouted bed reactor. This provides gas to be burnt in a gas turbine, and char which is burnt in a circulating …
Though the amount of brown coal resources in the world is abundant, and its moisture content is often high (more than 30%, wet basis). Thus, fluidized bed drying systems, using superheated steam for fluidizing gas, has been developed as a large capacity and low energy consumption drying technology. ... However, particle …
According to the ASTM International (previously known as American Society for Testing and Materials) coal classification (A. Standard, "D388-05 in Classification of …
DOI: 10.1016/j.fuel.2023.129596 Corpus ID: 261218259; Effects of dust concentration, particle size, and crude oil concentration on the explosion characteristics of oil-immersed coal dust
In the paint and pigment industries particle size infl uences appearance properties including gloss and tinctorial strength. Particle size of the cocoa powder used in chocolate affects color and fl avor. The size and shape of the glass beads used in highway paint impacts refl ectivity. Cement particle size infl uences hydration rate & strength.
This is due to the employment of biomass with large particle size has mass transfer resistance, which hinders the water-gas shift and hydrocarbon reforming reactions on the biomass carbon matrix under the oxygen-steam atmosphere, resulting in the enhancements of CO and C 2 H 4. Since all the above reactions are gas homogeneous …
Comparative kinetic study of coal gasification with steam and CO2 in molten blast furnace slags. Korean Journal of Chemical Engineering 2018, 35 (8), 1626-1635.
ent when the raw coal is directly gasied without pyrolysis. The model by Saer et al. (Saer et al. 1988) for uidized bed coal gasication ts the experimental conversion pro-le but fails to justify gas compositions. Xu et al. (2011a, b) developed a mathematical model for coarse char particle steam gasication but did not consider non-isothermal heat
Plasma gasification is widely applied because of its clean syngas production performance and high chemical reactivity accelerated by the free radicals produced by …
SE directly affects the composition and physical properties of coal, such as density [4], particle size, porosity [5], and moisture reabsorption capacity [6]. In the case of lignite, …
For coal, the inversion temperature exhibits a minimum as gas flow rate and particle size increase; it decreases steadily with the increase of coal permeability. Acknowledgements The authors would like to thank the National Science Foundation (OSR-955047) and the Department of Energy (DE-FC02-91ER75680) for financial support of …
The size of coal particles in the experiments did not exceed 60 μm, and of the wood - 5 mm. It has been established that in such a fuel system one of the fuel components of the coal particle is "conducting" (or leading), and the second is "conducted" in the reaction of the thermochemical response of the fuel mixture with air oxygen.
In other words, the injection of steam significantly hasten coal ignition by 14 ms at the large particle loading of 1 g/min but slightly reduce coal ignition by 1–2 ms at low particle loading, For the oxy-fuel combustion mode, the variation of particle ignition time upon steam injection is rather constant for all the particle loadings.
Preliminary experiments conducted show that the particle size smaller than 160 ?m can eliminate heat and mass transfer effect, and the most of volatile matter was released by heating the raw coal ...
Grades of steam coal are generally related to sulfur content and ash yield. Typically, the term low-sulfur coal is used for coals with less than 1 percent sulfur. In the United States, the Clean Air Act Amendments (1990) set a limit for sulfur emissions at power plants of 1.2 pounds of sulfur per 10,000 Btu, which amounts to approximately 1 …
Yoon et al. [24, 25] studied the effect of oxygen, steam and coal particle size on the syngas production by microwave plasma gasification of four kinds of coal. Djebabra et al. [26] studied the ...
The single-particle combined pyrolysis and gasification characteristics of Indian sub-bituminous coal in the presence of steam and CO2 is investigated separately in a custom-made reactor under isothermal condition (800 to 950 °C). A comprehensive transient model consists of two sub model—coal devolatilization and residual char …
Characterizing the coal particle size distribution is an effective means to reduce potential safety hazards in smart mine construction for disaster prevention and security management. Aiming at the existing approach, pixelwise manual labeling on low-contrast particle images that have irregular contours is challenging and time consuming. …
SE directly affects the composition and physical properties of coal, such as density [4], particle size, porosity [5], and moisture reabsorption capacity [6]. In the case of lignite, SE treatment engenders an augmented count of mesopores within the 6–12 nm range, reshaping its adsorption behavior significantly [7].
Gas (i.e. methane and CO 2) ad-/desorption characteristics are essential for unconventional gas production, and they are related to many factors such as coal particle size, adsorption pressure, external moisture and heat.In order to investigate the effect of these factors, as well as those arising from pressured water and superheated steam on …